Name |
Specifications |
| Model No |
STC-SS1200 |
| Imager |
⅓” Interline XGA Monochrome Progressive CCD: ICX204AL |
| Total Picture Element |
1077 (H) x 788 (V) |
| Effective Picture Element |
1034 (H) x 779 (V) |
| Active Picture Element |
XGA: 1024 (H) x 768 (V) |
| Chip Size |
5.8 (H) x 4.92 (V) mm |
| Cell Size |
4.65 (H) x 4.65 (V) µm |
| Scanning System |
Progressive |
| Scanning Method |
Full Scanning, Partial Full Scanning, ½ Partial Scanning,¼ Partial Scanning, Variable Partial Scanning, Binning, Binning Partial Scanning, Binning ½ Partial Scanning, Binning ¼ Partial Scanning, Binning Variable Partial Scanning |
| Vertical Frequency |
29.59 Hz |
| Horizontal Frequency |
23.23 kHz |
| Pixel Frequency |
29.5 MHz |
| S/N Ratio (Standard Deviation) |
56 dB (GAIN 0 dB) |
| Minimum Illumination |
1 Lux at F1.4 |
| Sync System |
Internal / External |
| Video Output |
1.0 Vp-p / 75Ω, DC Coupling (0V) |
| Shutter Speed |
|
| - Dip Switch |
OFF; 1/200; 1/500; 1/1000; 1/2000; 1/4000; 1/8000; 1/20,000 sec |
| - Communication |
OFF; ½ to 100,000 sec. (Variable at every H and Clock) |
| Gain |
0 to 27 dB |
| Gamma |
1.0 / 0.45 |
| Power Supply |
| - Input Voltage |
DC 12V ± 10% |
| - Consumption |
Less than 1.8W |
| Trigger Mode |
Edge Preset Trigger (V-reset, Non-reset) Pulse Width Trigger (V-reset, Non-reset |
| Communication |
RS232 via 12 Pin Connector |
| Dimensions |
28(H) x 28(W) x 46.3(D) mm (including the lens mount and connector) |
| Optical Filter |
No IR Cut Filter |
| Optical Center Accuracy |
Positional Accuracy in H and V directions: +/- 0.31mm |
| Material |
|
| - Case |
Front, Base, and Rear: Aluminum Die Cast (ADC 12) Cover: Steel Sheet Covered with Zinc |
| - Tripod |
Polycarbonate ABS |
| Lens Mount |
C Mount |
| Interface Connector |
HR10A-10R-12PB (Hirose) or Equivalent |
| Tripod |
Tripod can be attached to 4 plates(4 screws on the bottom plate, 3 screws on the other 3 plates) |
| Weight |
Approximately 52g (Camera: 43g, Tripod: 9g) |
| Temperature and Humidity |
|
| - Operational |
Temperature: -5 to 50 deg C; Relative Humidity: 0 to 85% (No Condensation) |
| - Storage |
Temperature: -30 to 65 deg C; Relative Humidity: 0 to 90% (No Condensation) |
| Vibration |
20Hz to 200Hz to 20Hz (5 min./cycle), Acceleration 10G, 3 Directions 30 Minutes Each |
| Shock |
Acceleration 70G, Half Amplitude 6ms, 3 Directions 3 Times Each |
| Standard Compliancy |
EMS: EN61000-6-2, EMI: EN55011 (Class B) |
| RoHS |
RoHS Compliant |