Model No STC-CL232A
Imager 1/1.8” interline UXGA monochrome progressive CCD: ICX274AL
Total Picture Element 1688 (H) x 1248 (V)
Active Picture Element 1620 (H) x 1236 (V)
Chip Size 8.5 (H) x 6.8 (V) mm
Cell Size 4.4 (H) x 4.4 (V) µm
Scanning System Progressive
Scanning Methods Full, Partial full, ½ partial, ¼ partial, Variable partial, Binning (Partial, ½ partial, ¼ partial, Variable partial)
Vertical Frequency (Frame Rate)
30.854 Hz
Horizontal Frequency 38.352 kHz
Pixel Frequency 73.636 MHz
S/N Ratio
- @ 8Bit Output ≤ 4 Digit (Gain 0 dB)
- @ 10Bit Output ≤ 15 Digit (Gain 0 dB)
Minimum Scene Illumination 0.07 Lux @ F1.2, 50 IRE
Sync System Internal
Video Output Digital 8 or 10 bit CameraLink® (Base Configuration)
Tap 2 Tap (The frequency of the clock output at CameraLink: 36.818 MHz)
Shutter Speed OFF, 1/9 to 1/240,000 seconds (Variable at every H and clock)
Gain 0 to 25 dB
Gamma 1.0
- Input Voltage 12 Vdc ± 10%
- Consumption < 4.0 W
Trigger Mode Edge preset trigger (V-reset, Non-reset); Pulse width trigger (V-reset, Non-reset)
Communication RS232 via CameraLink® connector
Dimensions 28(W) x 28(H) x 36.5(D) mm (Not including lens mount or the connector)
Optical Filter No IR cut filter
Optical Center Accuracy Positional accuracy in H and V directions: +/- 0.31 mm Rotational accuracy of Hand V: +/- 2.1 deg.
- Case Front, base, and rear: Aluminum die cast (ADC12) Cover: Steel sheet covered with zinc
- Tripod Polycarbonate ABS
Lens Mount C mount
Power I/O Connector HR10A-7R-6PB (Hirose) or equivalent
Tripod Tripod can be attached to 4 plates (4 holes on the bottom plate, 3 holes on the other 3 plates)
Weight Approximately 75.5g (Camera: 65.5g, tripod: 10g)
Temperature and Humidity  
- Operating Temperature: -5 to 40 deg C; Relative Humidity: 0 to 85% (No condensation)
- Storage Temperature: -30 to 65 deg C; Relative Humidity: 0 to 90% (No condensation)
Vibration 20 Hz to 200Hz to 20Hz (5min./cycle), acceleration 10G, 3 directions 30 min. each
Shock Acceleration 70G, half amplitude 6ms, 3 directions 3 times each
Standard Compliancy EMS: EN61000-6-2, EMI: EN55011 (Class B)
RoHS RoHS compliant