Name

Specifications

Model No STC-CLC152A
Imager ½” interline SXGA monochrome progressive CCD: ICX205AL
Total Picture Element 1434 (H) x 1050 (V)
Active Picture Element 1360 (H) x 1040 (V)
Chip Size 7.6 (H) x 6.2 (V) mm
Cell Size 4.65 (H) x 4.65 (V) µm
Scanning System Progressive
Scanning Methods Full, Partial full, ½ partial, ¼ partial, Variable partial, Binning (Partial, ½ partial, ¼ partial, Variable partial)
Vertical Frequency (Frame Rate)
15.28 (15fps) / 19.3 (19fps) Hz
Horizontal Frequency 15.998 (15fps) / 20.57 (19fps) kHz
Pixel Frequency 28.6363 (15fps) / 36.8181 (19fps) MHz
S/N Ratio
- @ 8Bit Output ≤ 3 Digit (Gain 0 dB)
- @ 10Bit Output ≤ 10 Digit (Gain 0 dB)
Minimum Scene Illumination 0.12 Lux @ F1.2, 50 IRE
Sync System Internal / External (HD/VD)
Video Output Digital 8 or 10 bit CameraLink® (Base Configuration)
Tap 1 Tap
Shutter Speed OFF, 1/3 ~ 1/93,000 (15fps); 1/5 ~ 1/120,000 (19fps), (Variable, can be set at every H and clock)
Gain 0 ~ 27dB
Gamma 1.0
Power Supply
- Input Voltage 12 Vdc ± 10%
- Consumption Less than 2.5 W
Trigger Mode Edge preset trigger (V-reset, Non-reset); Pulse width trigger (V-reset, Non-reset)
Communication RS232 via CameraLink® connector
Dimensions 28(W) x 28(H) x 29.5(D) mm (Not including lens mount and the connector)
Optical Filter No IR cut filter
Optical Center Accuracy Positional accuracy in H and V directions: +/- 0.31 mmRotational accuracy of Hand V: +/- 2.1 deg.
Material  
- Case Front, base, and rear: Aluminum die cast (ADC12) Cover: Steel sheet covered with zinc
- Tripod Polycarbonate ABS
Lens Mount C mount
Interface Connector HR10A-7R-6PB (Hirose) or equivalent
Tripod Tripod can be attached to 4 plates (4screws on the bottom plate, 3 screws on the other 3 plates)
Weight Approximately 52g (Camera: 43g, tripod: 9g)
Temperature and Humidity  
- Operating -5°C ~ 45°C (23°F ~ 113°F)
- Storage -30°C ~ 65°C (-22°F ~ 140°F)
Vibration 20 Hz to 200Hz to 20Hz (5min./cycle), acceleration 10G, 3 directions 30 min. each
Shock Acceleration 70G, half amplitude 6ms, 3 directions 3 times each
Standard Compliancy EMS: EN61000-6-2, EMI: EN55011 (Class B)
RoHS RoHS compliant