ULTRATOOL was designed
for manual polishing of fibers, either supported
(connectorized) or non-supported (bare fibers),
The tool uses various replaceable modules which
are available for all types of connectors --
if needed, custom modules can be designed and
manufactured by ULTRA TEC.
Key to ULTRATOOL's performance is a height
adjust feature that is controlled by a fine
pitch micrometer screw thread.
Flat, PC & APC polishes can be performed
on all standard connector types. Another common
use is bare-fiber polishing applications (flat
and angled). ULTRATOOL is capable of holding
bare fibers of the full size range and many
other materials such as small wafer sections
(for planar or edge polishes).
ImageOps, Division of Computer Modules, Inc. 11409 West Bernardo Court * San Diego, CA 92127 Phone: (858) 613-1818 *
Fax: (858) 613-1815