The Domino Iota is a high-quality and cost-effective board with one camera connector. It acquires images from a monochrome analog camera. This single-camera frame grabber is an ideal solution for cost-sensitive applications inspecting fast moving objects.

• One camera connector for:
  - One single-tap camera
• Multi-mode synchronization system, including pixel clock and PLL locking
• One 8-bit 32 MHz A/D converter
• PCI bus: 32 bits, 33 MHz, 3 V or 5 V signaling

One 8-bit 32 MHz A/D converter

The Domino Iota is equipped with an 8-bit A/D converter. The maximum sampling rate of 32 MHz allows the board to support double-speed cameras. This Domino frame grabber offers one 8-bit input look-up table and a programmable input filter (20, 10 or 5 MHz). The controls of the gain and offset are also programmable

Camera and I/O connectors

Bracket connectors: two HD15 video connector one RJ45 system connector

Camera Support

Beside standard CCIR and RS170 cameras, the Domino Iota supports any kind of single tap analog camera: with progressive or interlaced scanning, synchronous timing or asynchronous reset, shutter control or strobe control. The high-resolution capability of the board is compatible with top-notch analog cameras (mega-pixel cameras are supported). A multi-mode synchronization system is available and includes the pixel clock and PLL locking. The Domino series boards interface a wide range of cameras from many manufacturers.

32-bit 33 MHz PCI bus

The Domino Iota is 32-bit, 33 MHz PCI bus frame grabbers with 3V or 5V signaling. Direct Memory Access and PCI bus mastering are supported.